Graco 3A0415D Manual de usuario

InstructionsEM Drive Lubricators3A0415DENGProvides a continuous, precise and temperature independent supply of grease or oil lubrication to all lubric

Installation and Setup 10 3A0415DRemote Mounting InstallationsRefer to FIG. 7 and FIG. 8 for examples of cor-rect remote mounting installations.• Remo

Installation and Setup3A0415D 11From-top-lubrication of a Chain with OilA Clip, 124086B Support adapter, 124105C Bracket, 124087D Tube connector◆ (Use

Operation 12 3A0415DInstalling Lubricator to Lubrication Point1. Clean the lubrication point to remove any potential contaminants.2. Verify the thread

Maintenance3A0415D 13• The “TIME” switches 1 and 2 of the 4-way code switch in the drive unit match the desired discharge period.• All components are

Maintenance 14 3A0415DInstalling the New Lubrication Canister1. Install new battery pack in drive unit in the direction of the arrows as shown in FIG.

Troubleshooting3A0415D 15Lubrication Canister DisposalDispose of hazardous fluid in approved con-tainers, and according to applicable guidelines. Read

Parts 16 3A0415DPartsMiscellaneous AccessoriesMounting BracketsFitting AdapterPressure Relief ValveReplacement Cap400 Gram Lubricant CartridgesPart No

Technical Data3A0415D 17Refill KitsTechnical DataNoise data: Sound pressure level <70 dB(A) measured at distance of 1m (39.4 in.) / height 1.6m (63

Technical Data 18 3A0415DDischarge Amount per CycleWeights and MeasurementsDischarge PeriodPause TimeDischarge Amount per Discharge CycleEM-60 EM-120

Notes3A0415D 19Notes

2 3A0415DWarningsThe following warnings are for the setup, use, grounding, maintenance, and repair of this equip-ment. The exclamation point symbol a

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves th

3A0415D 3EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury.• Do not operate the unit when fatigued or under the influence of drugs or a

Component Identification 4 3A0415DPressure Relief Procedure1. Cover lubrication point (A) and lubricator (B) with a heavy rag to absorb any fluid that

Installation and Setup3A0415D 5Installation and SetupDetermining Correct Mounting MethodNOTE: • Direct mounting should be used for lubrica-tion points

Installation and Setup 6 3A0415DA pressure manometer is a simple device that measures pressure output. To build a pressure manometer you need a pressu

Installation and Setup3A0415D 7Circuit Board SettingsFunction DisplayRed and green LED’s (Light Emitting Diodes) are on the circuit board and visible

Installation and Setup 8 3A0415DSetting the Lubrication Canister Volume3. Use a small screwdriver or your finger to move dip switches to the desired p

Installation and Setup3A0415D 9Changing the Dip Switch SettingThe discharge period (Time) and/or lubrication canister size (Volume) can only be change