Graco HIGH EFFICIENCY LOW PRESSURE AA2000 Manual de usuario

INSTRUCTIONS-PARTS LIST mmucnoNtThis manual contains important warnings and information.READ AND RETAIN FOR REFERENCE<3ORACO307-947Rev. E Supersede

OperationFlush the Gun DailyWARNINGPressure Relief ProcedureTo reduce the risk of serious injury, including fluid injection, splashing in the eyes or

TroubleshootingWARNINGTo reduce the risk of serious injury, including fluid injection, splashing fluid or solvent in the eyes or on the skin, or injur

Service WARNINGTo reduce the risk of serious injury, including fluid injection, and splashing in the eyes or on the skin, or injury from moving parts

ServiceA A— DETAIL D —Fluid Needle Packings (47)A. AAAAAAAAAAAA A 30SERVICE NOTES:Gasket (33) must be replaced if fluid connector (67 or 1-see page 1

PartsA 33'For Direct Hose Connection(Paris shipped unassembled)SERVICE NOTES (See Fig. 7 for additional Information):A Gasket (33) must be replac

PartsUse Only Genuine Greco Parts and Accessories.Ref.No.Part No. DescriptionQty.1178-415 CONNECTOR, fluid (not assembled)12106-917ADAPTER, air13178-4

AccessoriesUse Only Genuine Grace Parts and AccessoriesFluid Filters3000 psi (207 bar) Maximum Working Pressure 214-570 with carbon steel bowl and sup

AccessoriesUse Only Genuine Grace Parts and AccessoriesAir Pressure Verification Kit 224-250For use in checking air cap pressure at various gun inlet

Spray Tip SelectionSTANDARD SPRAY TIPSOrificeSize(Inches)Inches Fan Width at 12” (300 mm)‘Light to Medium Viscosity fl oz/mln (llters/mln)‘Heavy Vis

Technical DataDimensionsMaximum Working Fluid Pressure ... 950 psi (66 bar)*Maximum Working Air Pressure...100 psi (7 bar)**Maximum Oper

Table of ContentsSafety Warnings... 3InstallationVentilate the Spray Booth...

The Grace Warranty and DisclaimersWARRANTYGraco warrants all equipment manufactured by it and bearing its name to be free from defects in material and

WARNINGSHigh Pressure Spray Can Cause Serious Injury. For Professional Use Only.Observe All Warnings. Read and understand all instruction manuals befo

FIRE OR EXPLOSION HAZARDstatic electricity is created by the flow of fluid through the pump and hose. If every part of the equipment is not properly g

EQUIPMENT MISUSE HAZARDGeneral SafetyAny misuse of the equipment or accessories, such as overpressurizing, modifying parts, using incompatible chemica

InstallationKEYAGun Air InletGPump Ground WireBGun Fluid InletHAir Line FiltercBleed-Type MasterJFluid Drain VaiveAir VaiveKGun Air HoseDMain Air Supp

Connect the Air LineInstall an air line filter (H) to ensure a clean, dry air supply to the gun. Dirt and moisture in the line can ruin the appear

OperationSelect a Spray TipUse the Spray Tip Selection charts on page 18, as a guide tor selecting an appropriate spray tip tor your application. The

OperationAdjust the Spray Pattern & Apply the Fluid (Continued)Increase the fluid pressure just to the point where a further increase in fluid pre