
Overview
10 313528E
Overview
System Description
Each tandem supply system consists of two air-powered
rams; both of which are always the same size. Each ram
drives a Check-Mate pump and a platen into a drum of
material. The pump removes material from the drum
and pushes it through a supply hose to a customer-sup-
plied header. Material flows through the header to indi-
vidual dispense drops.
When one drum is emptied the system performs an
automatic crossover, shutting off the air supply to the
pump on the empty ram and activating the pump on the
full ram.
Ram Installation and Setup
1. Install and set up individual rams as explained in
manual 313526 (supplied).
NOTE:
See F
IG. 2 on page 13 (for pneumatic crossover sys-
tems) and F
IG. 3 on page 15 (for electronic crossover
systems) for examples.
2. Connect pneumatic line (AC) or CAN cable (X)
between rams.
Fluid Filter Kit Installation
Some systems include a fluid filter kit. See Appendix A
- User Interface Display on page 31. Ensure that the
fluid filter stand base is level in all directions. If neces-
sary, level the base using metal shims. Secure the base
to the floor using anchors that are long enough to pre-
vent the filter stand from tipping.
1. Connect pressure sensor cable from the fluid filter
kit to port 7 of the fluid control module.
2. Connect male side of the splitter to the other end of
the pressure sensor cable.
3. Connect end of splitter cable labeled #1 to the pres-
sure sensor on the outlet side of the filter.
4. Connect end of splitter cable labeled #2 to the pres-
sure sensor on the inlet side of the filter.
Keep clear of the inactive ram, as automatic crossover
may occur unexpectedly. To repair or adjust the ram,
first follow all steps of the Pressure Relief Procedure
on page 22.
pressure sensor cable
#1#2
outlet
inlet
splitter
#7
Comentarios a estos manuales