Graco 313528E Manual de usuario descargar pdf (Pagina 29)

Alarms

313528E 29

Fluid Control Module (continued)

DA1X

DA2X

Pump Runaway A

Pump Runaway B

Pump is running faster than

set runaway limit due to:

• Increased air pressure.

• Increased fluid output.

• Exhausted fluid supply.

• Open fitting, hose, drain,

or bleed valve.

Correct runaway condition

and clear alarm.

Cleared from Ram Alarm

screen. See Appendix A -

User Interface Display,

page 31.

L11X

L12X

A - Drum Empty

B - Drum Empty

Drum empty sensor has been

activated.

Replace empty drum with

full drum to clear.

Alarm automatically

cleared by solution.

DB1X

DB2X

A - Not Primed

B - Not Primed

The pump is not primed. Set ram to Prime mode to

automatically clear alarm,

or manually clear alarm

from Ram Alarm screen.

Cleared from Ram Alarm

screen or Ram Operation

screen. See Appendix A -

User Interface Display,

page 31.

WJ1X

WJ2X

A - Air Solenoid Discon-

nected

B - Air Solenoid Discon-

nected

Solenoid unplugged. Check that solenoid cable

is connected.

Alarm automatically

cleared by solution.

Damaged solenoid / wires. Inspect solenoid wires for

damage.

Alarm automatically

cleared by solution.

DK1X

DK2X

A - Air Motor Sensor Error

B - Air Motor Sensor Error

System has seen multiple up

strokes without a down stroke,

or multiple down strokes with-

out an up stroke.

See air motor manual. Cleared from Ram Alarm

screen. See Appendix A -

User Interface Display,

page 31.

Damaged or disconnected air

motor sensors.

Check that air motor sen-

sors are connected.

Inspect air motor sensor

harness for damage.

L21X

L22X

A - Drum Low Deviation

B - Drum Low Deviation

Drum low sensor has been

activated.

Replace empty drum with

full drum to clear.

Deviation automatically

cleared by solution.

WK1X

WK2X

A - Fluid Solenoid Discon-

nected Deviation

B - Fluid Solenoid Discon-

nected Deviation

Solenoid unplugged. Check that solenoid cable

is connected.

Deviation automatically

cleared by solution.

Damaged solenoid wires. Inspect solenoid cable for

damage.

ML1X

ML2X

A - Rebuild Platen Seals

B - Rebuild Platen Seals

Counter has reached pro-

grammed platen maintenance

interval.

Perform platen mainte-

nance; see Supply Sys-

tems Repair-Parts manual.

Cleared from Maintenance

screen. See Appendix A -

User Interface Display,

page 31.

MA1X

MA2X

A - Rebuild Pump

B - Rebuild Pump

Counter has reached pro-

grammed pump maintenance

interval.

Perform pump mainte-

nance. See Check-Mate

Displacement Pump man-

ual.

Cleared from Maintenance

screen. See Appendix A -

User Interface Display,

page 31.

Alarm

Code Alarm Problem Cause Solution Clear Alarm

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 45 46

Comentarios a estos manuales

Sin comentarios