Graco 313528E Manual de usuario descargar pdf (Pagina 14)

Overview

14 313528E

Electronic Crossover System Components

NOTE:

D200 and D60 sizes are used in electronic crossover

systems. See F

IG. 3. Before you install the system,

you should be familiar with the following compo-

nents.

NOTE:

Reference numbers and letters in parentheses in the

text refer to the callouts in the figures.

Both rams (A and B) include a Check-Mate Pump (C),

platen (D), integrated air controls (H), drum empty sen-

sor (E), and fluid control module (G).

Only Ram A includes the display module (F) and power

supply box (K).

Drum empty sensor (E). Signals drum empty condition.

Display module (F). Mounted on Ram A only. Provides

Run Mode status screens, Setup screens, and control

keys.

Fluid control module (G). See page 21.

Integrated air controls (H). See page 11.

Power supply box (K).

Air motor solenoid (Y). Solenoid is on when system is on

and in Run Mode, Recirculate Mode, or Prime Mode.

Solenoid is off when system is shut off or when in

Depressurize Mode, or the ram is in an Inactive Ready

Mode. Turns on in Recirculate Mode. The solenoid LED

will illuminate when the solenoid is on.

Depressurize/recirculate fluid valve (Z). Depressurizes

system when Depressurize Mode is active. Recirculates

fluid when Recirculate Mode is active.

To depressurize the system, press the Depressurize

key on the display module and select Yes when

asked if you want to depressurize the system. Follow

the Pressure Relief Procedure on page 22. Shutting

off power or removing power from the system will not

depressurize the system.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 45 46

Sin comentarios

Graco 313528E Manual de usuario Pagina 14