Graco 313528E Manual de usuario descargar pdf (Pagina 38)

Appendix A - User Interface Display

38 313528E

Run Mode Screens

Run mode screens are divided into six sections: ram

operation, heat zone operation, current system status,

preventative maintenance schedule, current alarms, and

error reports. The system starts in Run mode. If the sys-

tem is in Setup mode, press to enter Run mode.

Ram Operation Screen

The Ram Operation screen displays which ram (A or B)

is active, and how much volume remains in each drum.

This screen also displays the flow rate of the active ram.

When the fluid line is shown filled the system is on.

Depending on the current system status, users can per-

form the following procedures from the Ram Operation

screen:

• turn the air motor on and off;

• depressurize and pressurize the system;

• recirculate fluid within the active ram;

• prime the pump(s);

• and perform a manual crossover on tandem sys-

tems.

See Electronic Crossover Operation, page 22, for

instructions on all of these procedures.

The Ram Operation screen will display the appropriate

icon and highlight the corresponding soft key if the sys-

tem is:

• depressurized ,

• in Recirculate mode ,

• or if a ram is in Prime mode .

FIG. 29: Ram Operation Screen - Tandem System

Fluid line shown filled

when system is ON

Active ram is

highlighted

Current

mode

Flow

rate

Volume

Remain

-ing

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Sin comentarios

Graco 313528E Manual de usuario Pagina 38